Meisupii J review

Meisupii J

This is a small, cheap Japanese camera dating from 1951.  The camera is 104 x 70 x 59 mm and weighs 190g - this is quite light and is due to the aluminium alloy construction.  the only part that is not aluminium is the shutter which is brass.  The basic physical design is the one common to many cameras of the period and is loosely (very loosely) based on the Leica, the sine qua non of camera design of the time.  The following three photographs show the general similarity in outline and layout.

The Meisupii J has a number of knurled knobs and rings giving the impression that things can be adjusted.  of then two knobs on the top plate, only one turns - the film advance.  The two knurled knobs on the base plate do not turn and the two knurled rings on the lens/shutter housing also do not turn.

There are adjustments, however.  There are two shutter speeds - I and B.  I is Instantaneous and B is Bulb.  Instantaneous is around 1/50 seconds and B, as usual, leaves teh shutter open while the release is depressed.  the release button almost gives the impression that it is threaded for a cable release but it is not.

Also adjustable is the aperture with two f-stops - f8 and f11.  These are Waterhouse stops - holes in a moveable metal plate - rather than an iris diaphragm.  These holes have clearly been punched rather than drilled as the f8 stop is not quite circular.

The lens is a meniscus lens as far as I can see and does not appear to be coated..  The lens fascia is inscribed 'Meisupii 35' which suggests a 35mm lens which is slightly wide angled for 35mm film.

This camera takes Bolta film which is unperforated 35mm film wound onto a spool with backing paper like 120 film.  This was introduced in Germany in 1936 at as time when 35mm film was becoming popular but was not yet readily available in pre-filled cassettes.  Bolta format film was introduced into Japan in the late 1930s as Boltax film and was used until the late 1950s.

As with 120 film, the frame positions are indicated on the backing paper with numbers viewed through a window on the camera back.  Strangely, this window is coloured green rather than the usual red although with the introduction of panchromatic film (which was the usual film by 1951) the colour of the window is immaterial.

Praktica TL3 mayer

Praktica TL3, front view

lens: Meyer-Optik G?rlitz Domiplan
focal length:  50 mm
apertures:  f2.8 to f22
focus range: 0.75m to infinity
lens fitting: 42 mm thread
shutter: metal vertical focal plane
speeds: to 1/1000
flash: bulb or electronic
film size: 35 mm

This is a standard looking camera from between 1984 and 1986.  It is a fairly heavy (very heavy by modern standards) and large enough to hold in two hands.  The ergonomics - the layout of the controls - is, again, normal for the time.

This camera takes 42mm thread lenses (also known as Pentax thread) which means that lenses are readily available.  It is specifically designed to work with automatic lenses (those with a pin to stop down the lens) - when the shutter is fired, a cam presses the pin and closes the aperture.  This is not essential, though, and the camera works fine with fully manual lenses.  I have shot half my test film with my Soviet Helios-44 lens from my Zenit E.  So long as you remember to manually stop the lens down for both metering and picture taking there is no problem.

This is a fully mechanical camera and no battery is required for its operation.  It does, however, use a battery for the metering system.  This should be a mercury battery giving 1.3 volts but these are no longer available.  I am using an alkaline 1.5 volt alternative which 'should' cause the camera to underexpose but I have checked the results of the built-in meter with my Ikophot meter and they are in complete agreement.

This is an SLR camera and so both metering and focussing are conducted through the lens (known as TTL, for the uninitiated).  With an automatic lens fitted, metering is done by selecting either the shutter speed or aperture, holding down the metering lever beside the shutter release and the adjusting either the aperture or the shutter speed until the needle in the viewfinder is as close to the circle as possible (i.e. it is a match-needle meter).  With the supplied lens, this is within 1/2 stop of 'perfect', with the Helios-44 it is to the nearest whole stop.The meter can be set to a range of film speeds from 12 ASA/12 DIN to 1600 ASA/33 DIN.  It is settable in 1 DIN stages which equates to 1/3 stop.

top and rear view

The shutter is a vertical metal focal plane shutter.  It has a good range of speeds - up to 1/1000 seconds which is plenty fast enough for my photography.  There are two flash synchronisation speeds: 1/30 for bulbs and a separate position on the speed selector dial for electronic flash, which the manual says is 'about 1/125.  Both bulbs and electronic flash can synchronise at slower speeds.

Electronic flash can synchronise at 1/125 seconds (quite a high sync speed for the time) because this camera has a vertical shutter with three metal blades.  In the manual, Praktica tout this as a modern invention but Zeiss Ikon used a vertical metal shutter in the Contax I in 1932

The shutter release is not my favourite part of this camera.  It is placed on the front of the camera rather than on the top plate which I always find awkward.  Secondly, the shutter release has to be pressed flush with the housing.  this might be just my camera but a little less travel would be good. The film winder is a lever which travels through 180 degrees but the first 20 or so degrees do nothing.

On top of the prism is an accessory shoe which has 'hot' contacts for a flash gun.  This is the only way of connecting a flash gun as there is no PC connector.  The only other control on the top plate is the film rewind crank.  As was normal for the time, this is an annoyingly small folding crank.  in the early 1960s several manufacturers introduced a large rewind crank on the base plate and it is a pity this did not become the standard.

Pressing the shutter release, you experience a significant resistance and then there is a loud and tactile 'clunk'.  I had thought my Zenit E had a heavy action but this is much worse.  I am hoping that most of this is the mirror slapping up and not the shutter.

The supplied lens is a Meyer Optik Domiplan f2.8 50mm lens.  this is a triplet lens and a cheap option.  I have yet to see the results of this lens but I have a 50mm Domiplan on my Exa IIa and that lens is fine.  Available apertures are from f2.8 to f22 in 1/2 stop clicks.

Focussing is from 0.75m to infinity and the focussing scale is in feet as well as metres.  The action is fairly stiff and changing the focus from near to far will result in the lens unscrewing rather than focussing.  Hopefully, this is lack of use and will sort itself out with use rather than being down to physical damage.